Accessories
Adhesive for leather wall tiles
Ranger
€ 24,95
Prices incl. VAT, excl. shipping costs
Description
The adhesive is used to apply on non-absorbent surfaces so that you can then stick the tiles on the wall. The recommended method is to apply the adhesive using a notched trowel. Make sure that the adhesive is spread evenly, not too thick nor too thin. It should not be lumpy but should feel moist. Work in sections or rows to maintain control and prevent the adhesive from drying prematurely.
The adhesive is available in 1-liter containers.
Information about Accessories
Adhesive for leather wall tiles
Ranger
Installation/Processing.
Make sure the adhesive is placed 24 hours in advance at the location where you intend to use it. The temperature of the environment is important for the level of adhesion. This way, the leather, adhesive, and wall will have the same ambient temperature.
Apply the adhesive to the wall using a notched trowel. Allow the adhesive to air dry until it becomes transparent, taking into account the amount applied, the absorbency of the surface, ambient temperature, and humidity. This process will take approximately 10 minutes, depending on the substrate.
Afterward, you can install the leather wall tiles. Rub or roll the tiles without applying tension.
Environmental factors
- Do not work at temperatures below +5°C!
- The ideal processing temperature for the material, substrate, and environment is between +15°C and +25°C.
- The ideal humidity level is between 40% and 60% relative humidity.
- Increased humidity and/or lower temperatures slow down the drying, setting, and curing time, while decreased humidity and/or higher temperatures accelerate the drying, setting, and curing process.
